Chandeliers CH20

Sirius

Print Specs Request a Quote
Chandeliers - Sirius - 1 Chandeliers - Sirius - 2 Chandeliers - Sirius - 3 Chandeliers - Sirius - 4 Chandeliers - Sirius - 5 Chandeliers - Sirius - 6 Chandeliers - Sirius - 7

Description

Designed by PAUL RUDOLPH

  • Approx. 15” diameter rings, which are spaced along the vertical rods [Custom diameter rings may be available—please inquire.]
  • Pattern of Rings can be a “Spiral” (as the rings descend the fixture) -or- a ”Cloverleaf”
  • Almost any length (“Drop”) and number of rings possible
  • Transformer is necessary
  • Dimmable

Finishes

  • Polished Chrome
  • Polished Nickel
Click here for more details on available finishes.

Sizes

Ring Diameter: Typically approximately 15” in diameter (and each typically receives 6 lamps). [Custom diameter rings may be available—please inquire.]

Overall Width: Approximately 33”

Typical Drop (the distance FROM the face-of-ceiling TO bottom-tip-of-suspension-rods): Typically it is up to a maximum of 72”(specified in units-of-an-inch)

Longer Drops: Drops exceeding 72” will be considered (please inquire).

NOTE: All dimensions are approximate.

Light Sources

JC Xenon lamps (typically six lamps per Ring)
Base: Bi-Pin, G4
12 Volts
5 or 10 Watts (each lamp)
Ring wattage: if using 5 watt lamps x 6 = 30 watts (total each Ring)
Ring wattage: if using 10 watt lamps x 6 = 60 watts (total each Ring)
Transformer necessary

NOTE: Fixtures are provided with a set of lamps (or, if specified or integral to the fixture’s design, with LED’s), as specified by the customer. It is the customer’s responsibility to verify that their selection is compatible with their wiring, power, switching, and dimming system.

Mounting Methods

  • MM01C (suspended by rods, and hardwired at ceiling behind a 6-1/2” round-domed plate, with a "Modern Cap" screw visible at center of the plate)

NOTE: Fixtures will be provided for installation with normal mounting conditions. It is the customer’s responsibility to verify that they have selected a fixture and mounting method which complies with local codes (L.A.H.J.) and that they are installing the fixture in an approved manner.

Specify to Order

TO ORDER— PLEASE SPECIFY EACH OF THE FOLLOWING:

We’ll be happy to help you with these specifications!

  • Sketch: if you have a particular concept in mind, then sending us a drawing—even a rough sketchwhich shows your design intention—is the a good way to start
  • Finish
  • Drop (the approximate distance FROM face-of-ceiling TO bottom-of-lowest-ring).
  • Number of Rings
  • Spacing of rings (if different from being evenly spaced)
  • Pattern of rings: Spiral -or- Cloverleaf?
  • Lamps: wattage (of each lamp)